kona4.0 linux
・・・flashromをインストール
anjii@pavilion:~$ sudo apt-get install flashrom
anjii@pavilion:~$ sudo flashrom
flashrom v0.9.9-r1954 on Linux 4.9.0-8-amd64 (x86_64)
flashrom is free software, get the source code at https://flashrom.org
Please select a programmer with the --programmer parameter.
Previously this was not necessary because there was a default set.
To choose the mainboard of this computer use 'internal'. Valid choices are:
internal, dummy, nic3com, nicrealtek, gfxnvidia, drkaiser, satasii, atavia,
it8212, ft2232_spi, serprog, buspirate_spi, dediprog, rayer_spi, pony_spi,
nicintel, nicintel_spi, nicintel_eeprom, ogp_spi, satamv, linux_spi,
usbblaster_spi, pickit2_spi, ch341a_spi.
パラメーター internal ・・・マザーボード
anjii@pavilion:~$ sudo flashrom --programmer internal
flashrom v0.9.9-r1954 on Linux 4.9.0-8-amd64 (x86_64)
flashrom is free software, get the source code at https://flashrom.org
Calibrating delay loop... OK.
========================================================================
WARNING! You seem to be running flashrom on an unsupported laptop.
Laptops, notebooks and netbooks are difficult to support and we
recommend to use the vendor flashing utility. The embedded controller
(EC) in these machines often interacts badly with flashing.
See the manpage and https://flashrom.org/Laptops for details.
If flash is shared with the EC, erase is guaranteed to brick your laptop
and write may brick your laptop.
Read and probe may irritate your EC and cause fan failure, backlight
failure and sudden poweroff.
You have been warned.
========================================================================
Aborting.
Error: Programmer initialization failed.
HP pavilionノートPCでは、linux のbios は受付ないようだ。
**************************************